highgasil.blogg.se

Seagate freeagent dockstar linux
Seagate freeagent dockstar linux













seagate freeagent dockstar linux seagate freeagent dockstar linux seagate freeagent dockstar linux
  1. SEAGATE FREEAGENT DOCKSTAR LINUX SERIAL
  2. SEAGATE FREEAGENT DOCKSTAR LINUX DRIVER

SEAGATE FREEAGENT DOCKSTAR LINUX DRIVER

html Warn : Adapter driver 'buspirate' did not declare which transports it allows assuming legacy JTAG - only Info : only one transport option autoselect 'jtag' srst_only separate srst_gates_jtag srst_open_drain connect_deassert_srst trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain connect_deassert_srst adapter_nsrst_delay : 200 jtag_ntrst_delay : 200 adapter speed : 500 kHz adapter_nsrst_delay : 500 Warn : use 'feroceon.cpu' as target identifier, not '0' dockstar_reset_cpu Info : Buspirate switched to FAST mode Info : Buspirate Interface ready ! Info : This adapter doesn 't support configurable speed Error: JTAG scan chain interrogation failed: all zeroes Error: Check JTAG interface, timings, target power, etc. cfg Open On - Chip Debugger 0.10.0 Licensed under GNU GPL v2 For bug reports, read http : // openocd. It turns out the clock from the DockStar was connected to the wrong pin on the Bus Pirate. : jtag - I rechecked my connections with this schematic, from this article. Check if the nand is there > nand probe 0 NAND flash device 'NAND 256MiB 3.3V 8-bit (Micron)' found > nand list #0: NAND 256MiB 3.3V 8-bit (Micron) pagesize: 2048, buswidth: 8, blocksize : 131072, blocks : 2048 check for bad blocks > nand check_bad_blocks 0 bad block : 40 bad block : 87 bad block : 167 bad block : 186 bad block : 340 bad block : 364 bad block : 389 bad block : 458 bad block : 548 bad block : 561 bad block : 566 bad block : 578 bad block : 595 bad block : 735 bad block : 788 bad block : 802 bad block : 806 bad block : 868 bad block : 911 bad block : 1028 bad block : 1178 bad block : 1359 bad block : 1523 bad block : 1707 bad block : 1778 bad block : 1779 bad block : 1866 checked NAND flash device for bad blocks, use "nand info" command to list blocks

SEAGATE FREEAGENT DOCKSTAR LINUX SERIAL

kwb 0x800000 524288 bytes written at address 0x00800000 downloaded 524288 bytes in 208.011993 s ( 2.461 KiB / s ) > resume ( and be ready to stop autoboot ) > resume 0x800200 but I couldn 't stop anything from the serial terminal. Continue debrick > dockstar_init > load_image uboot. init > soft_reset_halt requesting target halt and executing a soft reset target halted in ARM state due to debug - request, current mode : Supervisor cpsr : 0x000000d3 pc : 0x00000000 MMU : disabled, D - Cache : disabled, I - Cache : disabled looks much better.















Seagate freeagent dockstar linux